HT CABLE FLASHOVER

-
HT Cable Damaged  Report :




HT CABLE 
  1. HEAT BARRIER - HIGH TEMPERATURE SUSTAINING TAPE
  2. HT CABLE GOT DAMAGED DUE TO THIS  HEAT BARRIER GOT MELTED CAUSED FLASH OVER  AND BURNED THE OUTER SHEATH .
  3. DUE TO SUDDEN HIGH SYSTEM VOLTAGE CAUSE HEAT BARRIER TO GET MELTED .
  4. DUE TO CONTINUOUS HEATING IN CABLE , THE HEAT SHRINK MAY GET MELTED AND CAUSE DAMAGE TO CABLE ....

Comments

Post a Comment

Popular posts from this blog

ACB Tripping settings

-
Image
ACB tripping settings   Acb has 6 adjustable tripping settings 1 Long time delay (Tr ) 2 Short time delay( Tsd ) 3 Earth fault delay (Tg) 4 Long time (Ir) 5 Short time (Isd) 6 Earth Fault (Ig) Long time is for maximum overload capacity . Short time is for short circuit current Earth fault is for earth fault current . As per thumb Rule : 1. Long time set at 0.8 means 80% of full load current .Until this level of current  breaker carry without tripping  . Above 0.8 Acb trips. Long time delay causes the breaker to wait for certain time to allow heavy temporary inrush currents to pass away. Generally long time delay is set at  4 Sec. 2. Short time set at 0.6 means  60% of full load current . It determines the Amount of Current the Breaker will carry for short time period.  Generally short time delay set at 0.2 sec. 3. Earth Fault set at 0.3 or 30% of  fault current . It controls the amount of Ground Fault current that will caus...
Read more

Transformer Magnetic Oil Gauge Indicator

-
Image
conservator tank oil level (Mog) The MOG  (Magnetic Oil Gauge)  is a device by which we can supervise the level of oil inside the tank or conservator of power transformer and also gives us an alert low oil level indication .  A decrease in level of Transformer oil in Conservator is an indication of leak and therefore MOG level is an important parameter to be monitored. Practically under running condition oil level remains at 3/4 th level.
Read more

ISOLATION TRANSFORMER IN DATA CENTER

-
Image
ISOLATION TRANSFORMER  :  Outputs will be isolated from inputs. Since the output connection is totally isolated from input connection any fault like short circuit in primary winding are not reflected on secondary side . Any faults, harmonics or Electrical disturbances or surges in primary side of transformer  are not transferred to secondary side due to Galvonic isolation on primary side .  Interference can be restrained with it.  The neutral-ground voltage will be reduced.  Faults can be isolated.  Low-frequency 3n-order harmonics will  be restrained . Isolation transformers  are the only way of eliminating general mode noise.  They also provide better safety to any equipment by Galvanic isolation .  They separate the device from the main power supply upon any electric shocks. So, they ensure that the concerned electric and electronic appliances are safe and secured for a longer time.  Isolation transformers are used to ...
Read more